Does ProKure V Kill Botrytis in Cannabis Grows? Yes, on Hard Non-Porous Surfaces, with Plants in the Room
Yes. ProKure V is an EPA-registered chlorine dioxide (ClO2) liquid disinfectant and fungicide, EPA Reg. No. 87508-3-89334, and its label lists Botrytis among the fungi it controls on hard, non-porous surfaces at 100 ppm for a 10-minute exposure. The reference strain tied to that fungicide panel is ATCC 201167. The part a grower has to get right is the word surface: ProKure V is a surface fungicide, not a treatment you spray on the plant. It is suitable for use with plants in the room because it treats the bench, the wall, and the tool, not the flower.
That distinction is the whole answer. If you are fighting Botrytis, V attacks the environmental reservoir, the surfaces spores sit on between and during cycles, which is where a prevention program actually works.
The short answer, and what the label says
ProKure V's fungicide claim covers Botrytis Sp, listed on the label alongside Penicillium digitatum under the reference strain ATCC 201167, with Fusarium solani (ATCC 36031) and Aspergillus niger (ATCC 9642) rounding out the cannabis-relevant fungal panel. The parameter for the fungicide claim on hard, non-porous surfaces is 100 ppm at a 10-minute exposure. ProKure's own published guidance is blunt on the application boundary. Asked "Can ProKure V be used directly on plants?" the answer is "No, ProKure V is approved to use on hard, non-porous surfaces." Asked "Can ProKure V be used with plants in the room?" the answer is "Yes, ProKure V is suitable for use with plants in the room." Both are true at once because the product treats the surface, not the crop.
Why Botrytis is the number-one QA worry in cannabis
Botrytis, the gray mold behind bud rot, is the organism growers fear most because it moves fast in exactly the warm, humid conditions a flower room maintains, and because it drives the total yeast and mold count that state labs screen before a lot can sell. A positive result on a mature flower room is a six-figure event, which is the number a sanitation program is built to avoid. The organism travels on air, on hands, and on surfaces, so the surfaces between the last clean and the next are the controllable part of the chain. That is the part ProKure V is registered to handle.
What ProKure V is, and is not
ProKure V is a ClO2 liquid you activate from a dry foil-packet pouch in an opaque container of water to reach 100 ppm. It is a hard, non-porous surface fungicide and disinfectant: benches, walls, floors, drains, tables, tools, pots, and equipment housings. It leaves no residue, which is why it fits near a crop where bleach and quaternary ammonium cleaners leave carryover a grower has to rinse. What it is not: a foliar spray, a fog applied to the canopy, or a plant treatment of any kind. For the full product picture, see the ProKure V liquid disinfectant pillar, and for the master label and SDS, prokuresolutions.com.
How V differs from the ProKure gases
Do not substitute the gases for the surface job, and do not confuse their plant rules. ProKure G is a fast-release ClO2 gas, EPA Reg. No. 87508-2-89334, labeled "Not for use with/on plants/crops/feed," so it runs in an empty room only for a between-cycle air reset. ProKure D is a slow-release gas that provides ClO2 protection for up to 30 days and runs with plants in the room for air quality; ProKure D is not an EPA-registered product and not labeled for sale as a pesticide under 40 CFR, and it carries no kill claim. For Botrytis on surfaces, V is the registered fungicide. The gases do air, not a surface kill claim.
A Botrytis surface protocol for a live cannabis room
The claim becomes real only at the labeled parameter, so build the protocol around 100 ppm and the 10-minute hold.
Pre-clean, apply, hold
Pre-clean visibly soiled surfaces with a non-disinfectant cleaner first, because organic matter consumes oxidizer. Activate the pouch to 100 ppm in an opaque container, agitating one minute at 15-minute intervals until full activation at one hour, holding 20 to 25 degrees Celsius. Apply by sprayer, mop, or sponge to visible wetness on benches, walls, floors, tools, and drains, and hold the 10-minute contact time. ProKure V is a direct-application surface product; this is not a canopy fog. Keep the plants clear of the treated surface during application.
Verify and log
Record date, concentration, contact time, room ID, and operator. Use the activated solution within 15 days and write the activation date on the container. The same log that proves the result to you is the one a compliance auditor reads. For the broader program this fits inside, see the mold prevention protocols overview and the cultivation IPM reference.
Outbreak response versus standing program
On an active Botrytis event, tighten the surface cadence: disinfect hard surfaces with V at every entry to the affected room and between any task that touches multiple plants, and pair it with an empty-room ProKure G reset at the next turnover. As a standing program, the weekly deep-clean plus between-cycle reset keeps the surface reservoir low so a spore load never reaches outbreak scale. Either way, V is the surface fungicide and the gases handle the air.
To order ProKure V, visit shop.groclarity.com. For the EPA master label, the full kill-claim one sheeter, and SDS, see prokuresolutions.com, or reach GroClarity at 866.206.1301. Built on Science. Backed by Results.
Related resources


