Grow Room Cubic Feet Calculator for ClO2 Sanitation (Sized for ProKure D and G)

To size ClO2 for a grow room, multiply the room's interior length by width by height in feet to get cubic feet, then match that volume to a coverage-rated ProKure SKU. ProKure D covers roughly 1,000 cubic feet (10g pouch), 4,000 (50g), or 8,000 (95g); ProKure G covers about 1,000 cubic feet (10g) or 2,250 (25g). The reason you size by volume and not floor area is simple: ClO2 is a gas, and a gas fills the whole room, ceiling included. A 10 by 10 room with an 8-foot ceiling is 800 cubic feet; the same footprint under a 16-foot warehouse ceiling is 1,600. Measure the air, not the floor.

This is a ClO2 calculator, not a CO2 calculator

If you searched for grow-room sizing and landed on a CO2 page, you are not alone; almost every calculator online sizes CO2 enrichment for yield or CFM for airflow. One ranking tool opens by telling you to "Calculate how much CO2 will be needed to fill a grow room to the optimum level," and another explains that "adding more CO 2 may be beneficial if you care about yield." That is a different job. This page sizes chlorine dioxide (ClO2) for sanitation and air quality, the dose that helps you keep a clean room between crops, not the gas you add to feed photosynthesis. If you actually want CO2 enrichment or exhaust-fan CFM, those are separate calculators. Stay here only if you are sizing ProKure D or G.

How to measure your grow room in cubic feet

Use interior dimensions, measured corner to corner inside the room, and measure the real ceiling height rather than assuming eight feet. Length times width times height gives cubic feet. A worked example: a room 10 feet long by 10 feet wide by 8 feet high is 10 x 10 x 8, which is 800 cubic feet. A grow tent listed as 4 by 4 by 6.5 feet is 104 cubic feet. For a sealed room, measure to the ceiling you actually treat; for a warehouse bay, ceilings run 8 to 16 feet and that swing doubles your volume, so do not eyeball it. Round up when you are between numbers, because an undersized dose is the expensive mistake.

Why cubic feet drives ClO2 dosing

Here is the part the CO2 calculators never explain for ClO2. ProKure's gas products are coverage-rated by cubic feet because the ClO2 has to distribute through the entire air volume of the room to do its job. Undersize the dose and you leave dead zones. Oversize it and you waste product and push past the coverage the label describes. The coverage ratings are the sizing tool: you are not guessing a concentration, you are reading a cubic-foot number off a pouch and matching it to the cubic-foot number you just measured.

Cubic feet to ProKure SKU: the sizing table

Match your measured volume to the pouch. For larger rooms, use multiple pouches placed equally apart.

Measured room volumeProKure D (slow-release air quality)ProKure G (fast empty-room reset)---------Up to 1,000 cubic feetOne 10g pouch (covers about 1,000 ft3)One 10g pouch (covers about 1,000 ft3)1,000 to 2,250 cubic feet50g pouch, or scale D pouches to volumeOne 25g pouch (covers about 2,250 ft3)2,250 to 4,000 cubic feetOne 50g pouch (covers about 4,000 ft3)Two 25g pouches placed equally apart4,000 to 8,000 cubic feetOne 95g pouch (covers about 8,000 ft3)Multiple 25g pouches placed equally apartOver 8,000 cubic feetMultiple pouches placed equally apartMultiple pouches placed equally apart

Example read: a flower room of 20 by 40 by 10 feet is 8,000 cubic feet, so one ProKure D 95g pouch covers it, or a matched set of ProKure G pouches if you are resetting the room empty.

Shock reset or continuous air quality: which do you need?

This is the decision that changes which product you size, and getting it wrong is a safety error, not just a sizing error.

For an empty-room reset between cycles, you want ProKure G, the fast-release ClO2 gas (EPA Reg. No. 87508-2-89334). It works in 4 to 6 hours plus a one-hour ventilation window, and its label states verbatim: "Not for use with/on plants/crops/feed." Run G only in an unoccupied room, never with a crop present. That is the Facility Manager's between-cycle turnover tool.

For steady air quality with plants in the room, you want ProKure D, the slow-release ClO2 gas that improves air quality and controls odors and provides ClO2 protection for up to 30 days. It runs with a live canopy. That is the Head Grower's in-cycle layer. If you need surface disinfection while plants are present, that is a third product, ProKure V liquid (EPA Reg. No. 87508-3-89334), used at 100 ppm on hard surfaces, not a gas you size by cubic feet.

Room seal and multi-room facility math

A number off a tape measure is the starting point, not the finish. Room seal matters: a tightly sealed room holds the ClO2 concentration for the full dwell window, while a leaky room with gapped doors, open ducts, or an unsealed ceiling bleeds gas and shortens the effective exposure. If your room seals poorly, fix the obvious leaks before you dose rather than overdosing to compensate. Treat seal quality as a reason to seal the room, not a reason to buy a bigger pouch.

If you run a footprint rather than a single room, size each space on its own and sum the pouches. Add the flower rooms, the veg rooms, the mother and clone rooms, the dry rooms, and the cure rooms, each measured and matched to its own SKU, then total the per-cycle product count. A Cultivation Director standardizing across states gets the cleaner answer this way: the same measured-volume-to-SKU rule applies in every room in every jurisdiction, so the protocol is portable even when the state rules are not.

EPA labels to know before you dose

Before you place anything, know which product carries which status. ProKure G carries the verbatim restriction "Not for use with/on plants/crops/feed" and is empty-room only. ProKure D is not an EPA-registered product and carries the required disclaimer: "Not an EPA-registered product and not labeled for sale as a pesticide under 40 CFR." D makes no kill claims; it is an air-quality and odor tool. ProKure V is EPA-registered (87508-3-89334) and carries the surface kill claims. Confirm current label language and your state's pesticide rules before you adopt a product. See product label for specific instructions and claims. Once you have sized the room, a QA lead keeps the paperwork: the SDS, the current EPA label, and an application log noting the product, the pouch size against the room volume, the placement and planned replacement dates, and the operator. The deep label and SDS references live on prokuresolutions.com. Log ProKure D as an air-quality and odor step, never as a kill or disinfection step, because it carries no kill claims.

Frequently asked questions

Still sizing? These are the questions growers ask after the tape measure comes out.

Related resources