ProKure V vs G vs D: Which One Should You Buy First?
You do not need all three on day one, and anyone who tells you otherwise is selling a stack, not a solution. Buy the one that matches the problem in front of you. Active mold or mildew event right now: start with ProKure V, the EPA-registered liquid surface disinfectant. Between cycles, resetting an empty room: start with ProKure G, the fast-release gas. Rooms already clean, you want ongoing air quality: start with ProKure D, the slow-release gas that provides ClO2 protection for up to 30 days. Three products, three triggers. Here is how to pick yours.
The 60-second decision tree
Three branches, one question each. Do you have a problem today, are you resetting a room, or are you maintaining a clean one? An active surface problem routes to ProKure V, because it is the only one of the three with an EPA-registered disinfectant claim. An empty-room reset routes to ProKure G, the fast gas. Ongoing occupied-room air quality routes to ProKure D. Each branch has a sensible second buy, but the first buy is the one that answers the question you are asking this week.
What each product actually does
ProKure V is the liquid. Add water to activate, apply by mop, sprayer, or sponge, and it leaves no residue. The label directs a 10-minute exposure at 100 ppm on hard, non-porous surfaces, and it is suitable for use with plants in the room because it treats surfaces, not the crop. It is registered under EPA Reg. No. 87508-3-89334.
ProKure G is the fast-release gas, for an evacuated room: it controls odor-causing bacteria, mold and mildew, and chemical odors over four to six hours, then one hour of ventilation before re-entry. It is registered under EPA Reg. No. 87508-2-89334 and carries the disclaimer Not for use with/on plants/crops/feed.
ProKure D is the slow-release gas, for an occupied room: it provides ClO2 protection for up to 30 days, framed for air quality and odor control. It is not an EPA-registered product and carries the disclaimer that it is not labeled for sale as a pesticide under 40 CFR.
Which one to buy first
Buy ProKure V first if you have an active mold or mildew event. It is the EPA-registered disinfectant, it works on the surfaces where the problem lives, and you can run it with plants in the room, so you are not shutting down to treat.
Buy ProKure G first if you are about to reset a room between cycles. An empty-room gas treatment reaches the whole volume in one pass, which compresses a multi-day bleach reset into a four-to-six-hour cycle plus a vent.
Buy ProKure D first if your rooms are clean and you want hands-off ambient protection. One placement holds air quality for up to 30 days in an occupied room, so it is the maintenance buy rather than the emergency buy.
First-purchase picks by grower type
Single-room grower or facility manager: start with V for surfaces and D for ambient, then add G at your next reset. Established multi-room head grower: start with V and G, an active-event tool plus a reset tool, and add D for facility-wide ambient. MSO cultivation director: standardize on the full V, G, and D stack across rooms from day one and price by facility count. Owner weighing ROI: the stack for a 1,000 cubic-foot room costs a fraction of one failed pre-sale yeast and mold test on one harvest. Procurement or QA lead: decide packet size by room cubic footage and pull the SDS and EPA labels for V and G, plus the 40 CFR disclaimer for D, before you commit.
Room size and packet sizing
Before you buy, calculate the room: length times width times height gives cubic feet. ProKure G covers roughly 1,000 cubic feet per 10-gram pouch for standard odors and 2,250 cubic feet per 25-gram pouch. ProKure V dilutes to 100 ppm by pouch size and water volume per the label table. Size to the room, not the other way around, and pull the full sizing tables from prokuresolutions.com.
EPA compliance, read before you buy
This is the section a procurement lead reads first, so here it is straight. ProKure V is EPA-registered as a disinfectant under 87508-3-89334. ProKure G is EPA-registered as a deodorizing delivery system under 87508-2-89334 and carries Not for use with/on plants/crops/feed. ProKure D is not an EPA-registered product; its label states it is not labeled for sale as a pesticide under 40 CFR, and its claims stay on air quality and odor control. Do not borrow V's disinfectant claim for G or D. The current labels and Safety Data Sheets live on prokuresolutions.com for your audit binder.
What ProKure replaces in your current inventory
If you run bleach for surface work, ProKure V replaces it and leaves no residue. If you run quats, ProKure V is residue-free on a 10-minute dwell. If you run nothing for ambient air between cycles, ProKure D fills that gap for up to 30 days. The honest limit: none of the three replaces your integrated pest management program, your HVAC and dehumidification engineering, or state-mandated pre-sale testing. They are tools inside a protocol, not the protocol.
Related resources


