Here is the gap in the Wisconsin SERP. Position 2 is the Wisconsin Department of Health Services mold page, which is residential and occupational mold guidance with zero cultivation content. Position 1 is a home-grow legality explainer. Positions 4, 5, and 6 are a research paper, a lab-vendor education article, and an indoor-air testing vendor. Not one result in the top ten is a dedicated Wisconsin cannabis-and-hemp cultivation mold protocol. A Wisconsin grower looking for 'what do I actually do in my grow room' finds nothing operator-facing. That is the page this is.

The DHS moisture-first principle is the right starting frame even though DHS wrote it for buildings, not grow rooms. Mold is a water problem before it is a mold problem. In a grow room that translates to vapor-pressure deficit, dehumidification setpoints, and airflow that does not let humidity pool in the canopy, because the spore load that fails a hemp lot was almost always built by moisture the operator could see coming. Control the water and you control most of the risk before a single disinfectant is applied.

EPA registration is the baseline that applies in Wisconsin no matter what the state does or does not do about cannabis. A disinfectant used in a cultivation facility is a pesticide under FIFRA, and its EPA registration number, listed site of use, and use-pattern language on the label are what make a given application legal. Read the label, not the sell sheet. This is also where bleach and quaternary ammonium compounds fall short in a plant-adjacent space: residue and off-gassing become a next-crop problem, and neither gives you the documented, on-label trail an inspector wants to see.

That is why chlorine dioxide (ClO2) is worth understanding as a category. The ProKure line GroClarity sells is ClO2 chemistry, and the three products are not interchangeable. ProKure V (EPA Reg. No. 87508-3-89334) is a liquid surface disinfectant for hard, non-porous surfaces, used at 100 ppm with a 10-minute exposure time, and its label states it is suitable for use with plants in the room because it treats surfaces, not the crop. ProKure G (EPA Reg. No. 87508-2-89334) is the fast-release gas for the empty room, and it carries the required disclaimer Not for use with/on plants/crops/feed. ProKure D is a slow-release gas that improves air quality and provides ClO2 protection for up to 30 days; it is not an EPA-registered product and is not labeled for sale as a pesticide under 40 CFR, so it is never your kill or sanitation step. Keep each product's claim matched to the right product. See product labels at prokuresolutions.com for specific instructions and claims.

The protocol that holds up at audit is a documented sequence, not a cabinet of products. Between cycles, with the room empty of plants and people: physically strip and deep clean, run the ProKure V surface pass at 100 ppm for 10 minutes on benches, trays, walls, and tools (no residue, no rinse), then run ProKure G for the empty-room air reset at 4 to 6 hours followed by one hour of ventilation before re-entry. In-cycle, hold VPD and dehumidification setpoints and let ProKure D maintain air quality with the crop present. The part that satisfies a USDA hemp inspector is the record: log each room, each date, each parameter, keep the SDS and EPA labels for V and G on file, and pair it with before-and-after air sampling so you have a trend, not just a claim. For multi-state operators modeling Wisconsin as a future adult-use entry, standardize this one IPM and sanitation SOP now so Wisconsin plugs into an existing program the day the law changes.