The headline Colorado TYM limit, the one most operators quote, is less than 10 to the fourth power CFU per gram, which is 10,000 colony-forming units per gram. That applies to regulated marijuana flower and trim, to most regulated marijuana products, and to concentrate. If you only sell flower, that is your bar, alongside separate absence requirements: Salmonella absent in 1 gram, Shiga-toxin-producing E. coli absent in 1 gram, and Aspergillus flavus, fumigatus, niger, and terreus absent in 1 gram.

But the flower number is a trap if you make anything else, because Colorado does not hold TYM constant across product forms. That is the single most consequential fact on this page.

Why product form moves the limit by four orders of magnitude

Colorado tightens TYM sharply for products delivered to sensitive routes of administration. For products administered by metered-dose nasal spray or by vaginal administration, the TYM count must be 10 to the first power CFU per gram, which is 10. For rectal administration products, it is 10 to the second power, which is 100. So a cultivator who runs flower at the 10,000 bar and then formulates a metered-dose nasal product is suddenly held to a limit that is a thousand times stricter, on the same harvest's inputs.

The regulatory logic is route-of-administration risk: a product that bypasses the digestive tract or contacts mucosal tissue carries more infection risk from viable mold, so the state demands a far lower microbial load. For a cultivation director standardizing across a product portfolio, the practical rule is blunt: design the sanitation and environmental protocol to clear the tightest form you package, because a batch that passes for flower can still fail for a nasal or rectal product made from it.

How Colorado compares, and why the national range is so wide

Colorado's 10,000 CFU per gram flower limit sits in the North American majority band. Across US cannabis programs the TYM ceiling ranges from roughly 1,000 to 100,000 CFU per gram depending on the jurisdiction, per peer-reviewed work by Punja and colleagues published in 2023. Some states run stricter than Colorado (Illinois caps flower at 1,000), and three states (Florida, Maryland, and Connecticut) allow mold limits as high as 100,000 CFU per gram. A multi-state operator cannot assume Colorado's number travels; the limit that fails your batch in one state passes it in another.

Which ProKure product fits, and where the EPA line sits

TYM is a measure of viable yeast and mold on the harvested product, and the honest way GroClarity frames prevention is upstream: lower the microbial pressure in the room before the plant is ever tested. ProKure V is an EPA-registered hard-surface disinfectant, EPA Reg. No. 87508-3-89334, used at 100 ppm on hard, non-porous surfaces such as grow beds, benches, trays, and trim-room surfaces, suitable for use with plants in the room and leaving no residue. That is surface sanitation that reduces the spore load a crop is exposed to. ProKure G is a fast-release gas for empty-room air resets between cycles, labeled Not for use with/on plants/crops/feed. ProKure D is a slow-release gas for ongoing air quality up to 30 days.

What GroClarity will not tell you is that any ProKure product is approved to remediate a cannabis batch that has already failed a TYM test, or to be applied directly to the crop. ProKure products are not labeled for direct plant or crop remediation. If a batch fails, whether and how you may remediate (ozone, irradiation, or another method) and whether you must disclose it is governed by Colorado's cannabis rules, not by a disinfectant label. The product work is prevention: surface and air sanitation that keeps the TYM count under the Colorado threshold before the sample is pulled.

GroClarity consulting, from Phoenix

GroClarity works with Colorado cultivation operators on IPM and sanitation SOPs from its Phoenix base at 5013 E. Washington St. Ste. 130, Phoenix, AZ 85034, reachable at 866.206.1301. For a compliance lead standardizing across a product portfolio or a multi-state footprint, the useful conversation is which threshold to design to and how to document an air-and-surface protocol that holds TYM below the tightest form's limit. That is consulting work, and it routes to a quote rather than a product cart.

What to confirm before you act

Treat this page as the shape of the Colorado rule, not the version that governs your batch today. Microbial action levels and product-form categories are updated by the Marijuana Enforcement Division, so confirm the current CFU thresholds and the forms they apply to directly with the state regulator before you certify a batch or submit an SOP. Sibling GroClarity references cover the same topic for other states, each with its own threshold band.