ProKure V vs ProKure G: Liquid Disinfectant or Fast-Release Gas for Your Grow

ProKure V and ProKure G are both EPA-registered chlorine dioxide (ClO2) products, but they are not two versions of the same thing. ProKure V is a liquid you apply to surfaces, and it carries disinfectant kill claims. ProKure G is a gas that fills an empty room's air volume, and it is a deodorizer, not a surface disinfectant. The two also split on a hard rule: V is suitable for use with plants in the room, while G is not for use with plants, crops, or feed and runs only in an empty room. Keep the claims matched to the right product. V kills on surfaces; G deodorizes the air of a cleared room. Most turnovers use both, in sequence.

The short answer

Pick ProKure V when you are disinfecting a surface: tools, tables, totes, trays, grow beds, and other hard, non-porous surfaces, including spot work with plants nearby. Pick ProKure G when you want to treat the whole air volume of an empty room between harvests, fast, measured in cubic feet rather than square feet. Pick both when you run a full turnover: G to deodorize and reset the air of the cleared room, then V to disinfect the surfaces. The decision is surface versus air volume and occupied versus empty, not which product is stronger.

Side by side, the differences that decide it

Four differences drive the choice. Form and delivery: V is a water-activated liquid applied by mop, sprayer, or sponge; G is a water-activated gas released into the room's air. Coverage unit: V is measured by the surface area you keep wet, G by cubic feet of room volume (a 10-gram G pouch covers approximately 1,000 cubic feet, a 25-gram pouch approximately 2,250 cubic feet for standard odors). Room state: V can run with plants in the room on surfaces, while G requires an empty room with people and pets out, working in 4 to 6 hours before a one-hour ventilation and re-entry. Claim type: V carries disinfectant kill claims, G carries deodorizer claims. Both are EPA-registered, V under EPA Reg. 87508-3-89334 and G under EPA Reg. 87508-2-89334, so the difference is not registration status, it is what each is registered to do.

What ProKure V is

ProKure V is an EPA-registered hospital-type disinfectant, EPA Reg. No. 87508-3-89334, a water-activated liquid for hard, non-porous surfaces. Per aramsco.com (https://www.aramsco.com/2686-2894-prokure-v-4-2-oz-liquid-disinfectant-deodorizer-fungicide229886.html), ProKure V kills mold and mildew and kills SARS-CoV-2 on hard non-porous surfaces. Its approved language adds that it kills mold and mildew commonly found in greenhouses and indoor and outdoor agricultural facilities, is suitable for use with plants in the room, and leaves no residue. You activate the pouch in water to 100 ppm and apply to surfaces, keeping them visibly wet for a 10-minute contact time. Cultivators reach for V on tools, tables, totes, trays, drop-down hoses, and harvest surfaces, the hard, non-porous targets a surface disinfectant is built for.

What ProKure G is

ProKure G is an EPA-registered fast-release ClO2 gas, EPA Reg. No. 87508-2-89334, described as a deodorizing delivery system. Per livebiologic.com, ProKure G is formulated for use between harvests to control odor-causing bacteria, mold and mildew, and its approved language is the solution for mold and mildew, odor-causing bacteria, and chemical odors, with deep-penetrating ClO2 vapor that works in 4 to 6 hours. It is an empty-room product: you activate it with water in a dispersion cup, place it centrally, keep people and pets out, allow 4 to 6 hours, then ventilate one hour before re-entry. The label states it is not for use with plants, crops, or feed, so it does not run around a live canopy. Its value is treating the entire air volume of a cleared room, reaching cracks and crevices a liquid cannot, which is why it owns the between-harvest air reset.

When to choose which, and why growers run both

The verdict, no hedging. If you are disinfecting a surface, use ProKure V, because it is the product with disinfectant kill claims and it can work with plants in the room. If you are resetting the air of an empty room between harvests, use ProKure G, because it treats the full cubic-foot volume fast and is built for a cleared room. If you run a real turnover, use both in sequence: ProKure G to deodorize and reset the empty room's air, then ProKure V to disinfect the hard surfaces. Air volume first, surfaces second, each product doing the job it is registered for. GroClarity builds that two-product turnover protocol into its cultivation SOPs from Phoenix, AZ at 5013 E. Washington St. Ste. 130, Phoenix, AZ 85034, 866.206.1301. Order either on shop.groclarity.com, find full labels and SDS on prokuresolutions.com, and for a multi-facility rollout request an MSO comparison review through the GroClarity quote form.

Related resources